The principle of use of cycloid reducer

What are the precautions for the cycloid reducer during using? Let CAMEL to give you some popularization.

1. Cycloidal pinwheel reducer is suitable for 24 hours continuous working system, and allows forward and reverse operation.
2. The rotation of the output shaft of the single-stage cycloid reducer is opposite to that of the input shaft, and the rotation of the output shaft of the double-stage cycloid reducer is the same as that of the input shaft.
3. The cycloid reducer has no self-locking function.
4. The output shaft of the cycloid reducer cannot bear axial force.
5. In use occasions where overload may occur, an overload protection device should be installed.
6. The footplate type horizontal cycloidal pinwheel reducer should be installed on a very solid level foundation without vibration. In the use occasions that must be installed obliquely, the inclination of the reducer axis line should not be greater than ±15°.
7. When installing the flange type vertical cycloid reducer, the output shaft is vertically downward.
8. If it is necessary to adopt other special installation forms except for the footplate horizontal installation and flange vertical installation, corresponding lubrication and sealing measures must be taken to ensure adequate lubrication of the reducer and prevent oil leakage.
9. The installation angle of the cycloid reducer with grease lubrication is free.
10. When the reducer is installed, it can be adjusted with a pad. The height of the pad is not more than three, and it can also be adjusted with a wedge iron, but the flat pad must be replaced after the deceleration calibration.
11. In the occasion of high impact, vibration or frequent starting, the base and the foundation need to be reinforced with positioning pins (self-provided) in addition to the foot bolts for connection.
12. The shaft extension of the input shaft and output shaft of the standard cycloidal pinwheel reducer is cylindrical and connected by ordinary flat keys. Shaft diameter tolerance root number h6. The size of ordinary flat key is in accordance with GB1096-79 “Ordinary flat key type size”. The flange of the connecting flange is matched according to GB1801-79 (h9)
13. When a coupling is used to connect the cycloid pinwheel reducer with the matching machinery, an elastic coupling is recommended.
14. When the reducer is connected with the coupling for the machine to be matched, the concentricity of the two axis lines shall not exceed the allowable range of the coupling.
15. When the cycloidal pinwheel reducer is connected with the gear and sprocket, the parallelism of the axis of the two must be ensured.
16. When using sprocket for transmission, do not loosen the toothed chain too much, otherwise impact will be generated when starting.
17. When couplings, gears, sprockets and other couplings are connected to the output shaft of the cycloid reducer, direct hammering shall not be used. The bolts should be screwed in through the screw holes at the shaft extension and pressed in through the pressure plate. .
18. After installation, the reducer must be tested and run before formal use. Under normal no-load operation, load and operate gradually.